How to Tile Your Bathroom Floor Using Common Sense

HomeHome Improvement

  • Author Derek Farley
  • Published January 19, 2011
  • Word count 401

Common sense is your best friend when taking on a job such as tiling your bathroom floor. If you happen to ask more than one person how to go about it, then you are going to have more than one theory about what works the best.

Working on about any project certainly has its pitfalls. I have seen guys all my life tell me they were going to fix something on their car and would be over in 45 minutes to an hour, only to be tied up for several more. Well, with just a little research, like reading this article, you can get yourself pointed in the right direction quickly.

Basic steps. That's what you need. From there, if any problem arises, just be sure and know which step you are on, and which step you are working toward next. Anything in between is just something to solve before advancing.

First Step- The throne. The toilet must go. Be sure and turn your water off and flush, take a wrench to the brass fitting then take a screwdriver and remove your caps.

Faster isn't necessarily better. Don't rush. Think about each thing you are doing, and let common sense rule the day. Good common sense and logic is invaluable in this kind of work.

Next, go around and remove your molding from the base of the floor and wall. Be easy if you are going to use the same molding, as some do, and try not to break it.

Next mix your mortar. Be sure and use enough water, but don't make it too soupy. It's mud you're after. You will need a trowel to lay it down and spread it out.

Next Step is to lay your tiles out in whatever pattern you want them. As you lay them, push down on them gently to set them in the mortar and make them stick. Don't forget to use spacers for an even pattern.

Now you take a rubber grout float and some water and apply the grout. Wet-sponge the excess away.

A STEP REVIEW:

  1. Toilet goes

  2. Molding goes

  3. Mix Mortar - Apply Mortar

  4. Lay Tile

  5. Apply Grout

A bit later after things have dried, you can apply a sealer to your new floor. For now you have to backtrack and replace what you took off. No need for a plan for that, putting things back is just good common sense.

You can learn more about bathroom shower tile, and get much more information, articles and resources about bathroom tiles by visiting Bathroom Tile Designs

Article source: https://articlebiz.com
This article has been viewed 622 times.

Rate article

Article comments

There are no posted comments.

Related articles