Hardwood Refinishing Seattle

HomeHome Improvement

  • Author Wade Frazier
  • Published January 30, 2011
  • Word count 560

Rotary-peel

This process involves treating the wood by boiling the log in water at a certain temperature for a certain amount of time. After preparation, the wood is peeled by a blade starting from the outside of the log and working toward the center, thus creating a wood veneer. The veneer is then pressed flat with high pressure. This style of manufacturing tends to have problems with the wood cupping or curling back to its original shape. This problem is commonly known as "face checking" and is a manufacturing defect. Rotary-peeled engineered hardwoods tend to have a plywood appearance in the grain.

Sliced-peel

This process begins with the same treatment process that the rotary peel method uses. However, instead of being sliced in a rotary fashion, with this technique the wood is sliced from the end of a log, resulting in disc shaped veneers. The veneers then go through the same manufacturing process as rotary peeled veneers. Engineered hardwood produced this way tends to have fewer problems with "face checking", and also does not have the same plywood appearance in the grain. However, the planks can tend to have edge splintering and cracking due to the fact the veneers have been submersed in water and then pressed flat.

Dry solid-sawn

Instead of boiling the hardwood logs, in this process they are kept at a low humidity level and dried slowly to draw moisture from the inside of the wood cells. The logs are then sawed in the same manner as for solid hardwood planks. This style of engineered hardwood has the same look as solid hardwood, and does not have any of the potential problems of "face checking" that rotary-peel and slice-peel products have, because the product is not exposed to added moisture.

Floor finishes

The two most popular finishes for wood flooring are oil and polyurethane. Within both categories there are many variations and other names used to describe the finish. Oil and polyurethane also have very different refinishing and maintenance regimes.

  1. Oil - Oiled floors have existed for several thousand years and is the most common floor finish used globally. Oil finished floors are made from naturally derived drying oils, and are not to be confused with petroleum based oils. Pre-finished oil floors can be UV cured. Most vegetable based oils are 100% natural and contain no VOCs.

1.1) Brushed and Oiled

Steel brushes are used in the direction of the grain which opens up the surface of the wood and removes splinters. The wood is then oiled.

  1. Polyurethane

Polyurethane floors were first introduced around 1940. There are several types of polyurethane finishes that exist, but the two most common are straight polyurethane and oil-modified polyurethane. Both products are sold under various names including: urethane, lacquer, and varnish. Many finish manufacturers and wood flooring manufacturers create a brand name for their finish.

  1. Sanding

Sanding provides a method for smoothing an installed floor, compensating for unevenness of the subfloor. Additionally, sanding is used to renew the appearance of older floors. Sanding using successively finer grades of sandpaper is required to ensure even stain penetration when stains are used, as well as to eliminate visible scratches from coarser sandpaper grades used initially. Prior to modern polyurethanes, oils and waxes were used in addition to stains to provide finishes. Beeswax and linseed oil, for example, are both natural crosslinking polymers are hardened over time.

Welcome to our website to get more information about Randy M hardwood refinishing Seattle

Article source: https://articlebiz.com
This article has been viewed 762 times.

Rate article

Article comments

There are no posted comments.

Related articles