Installing a New Exterior Door

HomeHome Improvement

  • Author Jason Delmar
  • Published February 19, 2009
  • Word count 432

So you have decided to replace your existing door with a new Pre-Hung Exterior door

but aren’t quite sure how. This article should put your mind to rest and help you

successfully install your new door. You will need a few tools to complete the job such as:

A hammer, pry bar, cordless drill, sawzall, level, shims, screws, a circular saw(may not

be needed), caulk, and a pencil.

First you must remove the existing door and trim work around it. Start by removing

the trim work on the inside of the door, and also outside if need be. Once you remove the

trim you will be able to have a better look at the task at hand. Remove any insulation

that is stuffed between the jam and the frame. You should then be able to take your sawzall

and cut down through all the screws or nails holding the door in place. Be careful not to

cut any wires if you have a door bell installed. Once you have all the screws or nails cut

you should be able to put the door and frame right out.

Once you have made sure that there are no obstructions in place and the frame work

has no rot or other damage you can go ahead and prepare to put the new door in place.

Chances are the new door and jam are going to need some shims to make the door plum and

level. Once you have the door and jam in place check to make sure it is level and shim

the top as needed. Then check and make sure it is plum and add shims as needed and screw

the door jam into the frame work by screwing through the shims you’ve added. These shims

should be put in place behind the provided areas on the jam to screw through. Most new

doors will have a screw missing on the hinge side of the door where the hinges are

connected to the jam. This missing screw is purposely left out to allow you to put a

screw through there to secure the jam in place. Once you have the door secured in place

you can begin to insulate the door to make sure it is air tight. After doing this you can

go ahead and put the new, or if you’ve salvaged the existing trim, back in place. It is

always good to caulk between the trim work and the jam to give a nice finished look and to

provide a little more help in protecting against drafts.

I have been remodeling house for 15 years, and I have the secret to getting high qualitykitchen cabinetry at an affordable price. Interested in finding out my secret? Follow these links to find out the secret to getting kitchen cabinetry at 30-40% below retail prices

Article source: https://articlebiz.com
This article has been viewed 1,659 times.

Rate article

Article comments

There are no posted comments.

Related articles